(Answered): Please with tinkercad simulator Procedure AND Gate 1. Find the datasheet of the IC online by searchi ...

Procedure AND Gate 1. Find the datasheet of the IC online by searching the part number, i.e. 74LS08. As an example https://www.futurlec.com/74 S/74LS08.shtml 2. Use the datasheet to confirm the pin diagram of the IC, its function table, and operating conditions such as typical value of VCC and its absolute maximum ratings. Ensure that your operating conditions are within the limits given in the datasheets. 3. Place the 74LS08 IC on the breadboard. 4. Connect +5V to pin #14, and GND to pin #7 of the IC. 5. Connect a switch to pin #1 and another switch to pin #2 of the IC, using a pull-down resistor. 6. Connect an LED between pin #3 and ground through a resistor. You can also use a logic probe for this. 7. Connect power supply to the breadboard and turn it ON. 8. Observe the output from pin #3. Does it match the truth table? 9. Change the input combinations to verify if the truth table is correct. 10. For the lab report, take a picture of the hardware (including IC, Switches, and LEDs) providing evidence that the logic gate works as expected. 1 14 Vcc 13 2 AND gate 5 6 D Input 1 ? 0 0 1 1 Input 2 Y 0 1 0 1 Output O 0 0 0 1 GND 7 7408 Quad 2-Input AND Gate Repeat the same procedure as above for 1. 74LS04 - NOT Gate 2. 74LS32-2 input OR Gate 3. 74LSOO - 2 input NAND 4. 74LS10 - 3-input NAND gate 5. 74LS86-2 input XOR The symbol, IC diagram, and truth table for these gates are given in Appendix Lab Report 1. Prepare your report on an MS Word file. Do not forget to write your Name and student number. 2. Change the layout orientation of your Word File to 'Landscape' so that large sized pictures could be inserted in the file. 3. If the experiment uses hardware, then use your smartphone to take a picture of the complete circuit in working condition. Give different inputs to the circuit and take pictures that show both the inputs and the outputs. b. Include as many pictures as necessary to show the working of the circuit. 4. If the experiment uses a simulator, then take screenshots of the whole screen. The screenshot must cover the whole screen and it should include the simulator window, along with the time and date shown by windows at the bottom of the screen. b. Include as many screenshots as necessary to show the working of your simulation. a. a. Appendix Pin Diagrams of the Component ICs 7404 Hex NOT Gate 14 Vcc 2 3 NOT gate 5 6 GND 7 Input Output X O 0 1 1 0 NOT Gate 7432 Quad 2-Input OR Gate 14 Vcc 2 3 4 Input 1 ? 0 OR Gate 5 Output O 0 1 1 0 Input 2 Y 0 1 0 1 OR gate 6 GND 7 1 1 7400 Quad 2-Input NAND Gate 7400 Quad 2-Input NAND Gate -Q VCC Q. ANAND 8 1 2 Truth Table Input A Input B Output 0 0 1 NAND gate 4 5 6 0 1 1 1 0 1 GND 7 1 1 0 7486 Quad 2-Input XOR Gate EX-OR gate Input 1 X 0 0 1 1 Input 2 Y 0 1 0 1 EX-OR gate Output O 0 1 1 0